DIRECTIONS FOR USE:

BEFORE USING, READ ALL DIRECTIONS AND MATERIAL SAFETY DATA SHEETS #64010 (WOOD TONES) AND #64020 (WHITE) FOR THIS PRODUCT.

Use directly from the can, do not thin. Non-photochemically reactive (not an ozone precursor).

COMPATIBILITY STATEMENT:

BONA® DRIFAST™ STAIN is designed to penetrate, stain and seal bare wood and is compatible with all Bona® waterborne and all other Bona® finish systems. Bona does not recommend using white stain on white oak due to excessive color variation. Stain, sealer and finish results may vary widely depending on the wood species, especially on oily and resinous "exotics". ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY AND DESIRED RESULTS.

PREPARATION: SANDING AND FINISHING

1. Sand and prepare floor using NOFMA-accepted methods. Note: It may be necessary to first trowel-fill the entire floor, depending upon the extent of cracks between strip or parquet flooring.
2. For a stained floor, make your final cut with 80-grit paper and screen with 80-100-grit screen.
3. Vacuum thoroughly.
4. Tack with dry Bona® Microfiber Mop.
5. Apply stain, sealer and finish system (see directions).

DIRECTIONS FOR USE: STIR WELL BEFORE USING!

1. After preparing surface, apply BONA® DRIFAST™ STAIN with brush, cut-in pad or cloth in the direction of the grain.
2. Allow 1-3 minutes for penetration. Remove excess by hand wiping or buffing with an absorbent, non-abrasive material.
3. Allow stain to dry thoroughly (minimum 2 hours for wood tones; 6 hours for white under ideal conditions [65-80 degrees F, 40-60% relative humidity]). High humidity and/or low temperature conditions will extend dry time while increased ventilation and airflow will reduce dry time. The first coat of sealer or finish should be applied after the recommended dry time, but within 48 hours after application.
4. Apply any Bona® waterborne or any other Bona® finish system over thoroughly dried stain. Use Bona Strong®, Bona Traffic®, or Bona Naturale® over white stain. Bona does not recommend using Bonaseal® over stain when using Bona Traffic® or Bona Naturale®.

CLEAN-UP:

Clean application tools and equipment with mineral spirits.

STORAGE AND DISPOSAL:

Keep container closed when not in use. Do not transfer contents to other containers for storage and disposal. Do not return used material to original container; instead, use on a different application or dispose of. In case of spillage, absorb with inert material. Dispose of contaminated absorbent, container and/or unused contents in accordance with local, state and federal regulations.

NOTICE:

Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.

DANGER:

RAGS, STEEL WOOL OR WASTE SOAKED WITH BONA® DRIFAST™ STAIN MAY SPONTANEOUSLY CATCH FIRE IF IMPROPERLY DISCARDED. IMMEDIATELY AFTER EACH USE, PLACE RAGS, STEEL WOOL OR WASTE IN A SEALED, WATER-FILLED, METAL CONTAINER.